![]() How do you mount a drive? Is it permanently mounted, or only attached to the roof? If you want to set up a permanent mount point on the drive, label the partition. Changing permissions for the drive: operation is not permitted. It is impossible to access ‘Portable,’ and the file or directory associated with it are not visible. There is no way to access any of my files on my external hard drive because Plex recognizes it. But most likely, the problem is with your drive and not with Linux. If you still can’t get the drive to show up, there are a few other things you can try, like using a different USB port or trying a different cable. Replace “/dev/sda1” with the location of your drive, and “/media/plex” with the location where you want to mount the drive. Once you’ve located the drive, you can mount it by typing “ sudo mount /dev/sda1 /media/plex”. Sometimes Linux can be a little finicky about recognizing external drives. If you don’t see your drive listed, try unplugging it and plugging it back in. If you see your external drive listed, note the location (usually /dev/sda1 or /dev/sdb1). This will list all of the drives connected to your computer. Then, open a terminal window and type “fdisk -l”. First, make sure the drive is plugged in and powered on. But don’t worry, there are a few things you can try to get it working. The disk was quick formatted with NTFS when I got it.It can be frustrating when you can’t find your external drive on Linux, especially if you’re trying to use it with Plex. dev/sda, not /dev/sda1)? Or the other way around?Īlso some other stuff I’ve tried to no avail. dev/sda, not /dev/sda1)? Or the other way mount -t ntfs-3g /dev/sda2 /Media/Media The device '/dev/sda2' doesn't seem to have a valid NTFS. Or the NTFS boot sector is corrupt (NTFS size is not valid).įailed to mount '/dev/sda2': Invalid argument Or the partition table is corrupt (partition is smaller than NTFS), Or a wrong device is tried to be mounted, HINTS: Either the volume is a RAID/LDM but it wasn't setup yet, Ntfs-3g: Failed to access volume '/dev/sdc1': No such file or su -c 'mount /dev/sda2 /media/Media'įailed to read last sector (9767276542): Invalid argument dev/sda, not /dev/sda1)? Or the other way mount -t ntfs-3g /dev/sdc1 /media/Media Maybe the wrong device is used? Or the whole disk instead of a The device '/dev/sda' doesn't seem to have a valid NTFS. These are the commands I’ve tried: mount -t ntfs-3g /dev/sda /media/Mediaįailed to mount '/dev/sda': Invalid argument Hope to get to mount the 4.6 TB one soon slight_smile: Sector size (logical/physical): 4096 bytes / 4096 bytes The backup GPT table is corrupt, but the primary appears OK, so that will be used. I cannot make sense of this unfortunately.ĭevice Boot Start End Sectors Size Id Type The device /dev/sda2 (2.7 TB) is the old one, while disk /dev/sda (4.6 TB) is the new one. Have also tried through SSH with the root user, there are some errors given and messages indicating wrong or missing folders. It does not automatically mount, not possible to browse it or manually add it in OSMC. I managed to copy most of the data over to the new one. ![]() I’ve had to get a new USB external harddrive, as the last one showed behavior of failing. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |